Help
Charles Steinkuehler
Charles Steinkuehler
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 05/30/2015 | |
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 05/30/2015 | |
It seems like the screws holding the springs are unnecessary, and the plastic ends should just be designed with an integrated tab or post to hold the spring ends.
It seems like it would be easier to attach the endstops before the stepper motors. Also, the 20L's do seem a bit long. I used 16mm length screws I had on-hand, which worked fine.
Colors for m3 flat head and it's corresponding nut (green/yellow) are swapped between the text and the pictures.
Steps 4 and 11 seem like the same step. I am confused as to why they are distinct, and why the extrusion nut counts don't appear before step 4.
It looks like the top acrylic plate is supposed to be attached, but there is no step describing this.
The picture shows split washers under the 5mm bolts, but these are not mentioned in the text. The do show up in the PDF, but are hard to see (the pdf does not view well on google drive, or when printed out at 8.5x11, so you have to download and view in Acrobat to see things clearly).