To clarify, should the text read "do not attach bearing block caps to the delta arm mechanism" instead of "do not attach bearing blocks to the delta arm mechanism" ?
It is listed in step 11, but the text can be confusing, particularly since the picture on step 13 does not match what was supposed to happen in step 11.
My cables were not long enough to route like this
what screws were used on this step?
My end did not fit anywhere near this smoothly, required serious work with the dremel and utility knife to get it to snap in and out fully.
20L's seem a little long to me?
To clarify, should the text read "do not attach bearing block caps to the delta arm mechanism" instead of "do not attach bearing blocks to the delta arm mechanism" ?
It is listed in step 11, but the text can be confusing, particularly since the picture on step 13 does not match what was supposed to happen in step 11.
I had to drill out a hole for the screw in red, on all my pieces, I am wondering if the source files dont actually have a hole there?
A view of what your build should look like at the end of this step would be very nice to have.
Would be really handy to know how many extra extrusion nuts are in each of the rails.