-
-
If you haven't already, cut a small ~14mm section of tubing off of the large tubing piece. It will be needed with the NEMA 8 SMT stepper motor.
-
Put this small piece aside.
-
-
-
Insert DTB-0.0625-0.1875 into Large Silicone Tube
-
-
-
Locate the two pieces of 14" (~350mm) wire. Do not use the 18" wire found in the same bag (that's used for the NEMA 8 stepper motor)
-
Cut two pieces of 3/16" (~4.76mm) heat shrink tubing to ~15mm. These pieces were not included in the kit.
-
-
-
Solder the wires to the vacuum pump. Do this by stripping ~5-10mm of insulation off, and forming into a "hook" and threading this through the vacuum pump connections. Solder the connection and inspect the joint.
-
Cover with the heat shrink tubing, and shrink with a heat gun.
-
-
-
If you haven't built this part of the assembly yet, do so now.
-
Then, proceed toward the Final Wiring guide for this module.
-
Cancel: I did not complete this guide.
6 other people completed this guide.
One Comment
A good idea, I also want to try and apply it to do a vacuum like? But I do not know where to buy them
andy tondy - Resolved on Release Reply
