1
2
3
4
5
6
7
8
9
10
11
Introduction
Details
Guide Steps
Review
Quiz
Insert two M3 nuts into each orange arm, as shown in the second picture. NOTE: Only two of the holes will accept nut traps.
Insert two M3 x 30mm? pan-head machine screws into each orange arm. NOTE: Only insert the screws into the ROUND counter-bored holes.
Carefully assemble both orange arms and the black pulley as shown in the first picture. The nuts and screws are caddy-corner, so when facing each other, everything should line up nicely (nut to screw, etc).
NOTE: Do not fully tighten until you complete the next step
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.