Attach the fan module to the end effector.
Insert 4x M3 nuts on one of the three sides of the end effector. Two will go in the diffuser, and two into the black 3D printed housing.
Use 4x M3 x 16mm pan-head machine screws to attach the fan to the end effector. May not be in kit.
Orient the fan so that the wires exit the fan on the bottom part of the end effector.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.