Attach the camera module to the end effector.
NOTE: The camera should be complete per the Camera Module Assembly Guide, before attaching it in this step.
Insert 4x M3 nuts on one of the three sides of the end effector. Two will go in the diffuser, and two into the black 3D printed housing.
Use 4x M3 x 8mm pan-head machine screws to attach the camera module to the side of the end effector.
Note that the camera will be oriented to the FRONT of the machine.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.