Locate the ELED01 ring light PCB and place it on the 3DAT0011a ATC hub.
NOTE: We intended the ELED01 PCB to be an SMT practice kit. If you're building your machine for the first time, it is recommended to just assemble the camera with the blank PCB. You can always remove it later and use the SMT capability of the FirePick Delta to assemble the PCB, after you've commisioned the machine.
Note that the 3-pin connector will protrude from the bottom of the PCB when the board is assembled. Remove some material from the 3-d printed base to allow the PCB to sit flush.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.