Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Neil Jansen

Edit approved by Neil Jansen

Before
After
Unchanged

Step Lines

[title] Install Ring Light PCB
[* black] Locate the ELED01 ring light PCB and place it on the 3DAT0011a ATC hub.
[* black] NOTE: We intended the ELED01 PCB to be an ***SMT practice kit***. If you're building your machine for the first time, ***it is recommended to just assemble the camera with the blank PCB***. You can always remove it later and use the SMT capability of the FirePick Delta to assemble the PCB, after you've commisioned the machine.
+[* black] Note that the 3-pin connector will protrude from the bottom of the PCB when the board is assembled. Remove some material from the 3-d printed base to allow the PCB to sit flush.